Download Designing for Cisco Internetwork Solutions.examskey.200-310.2018-08-01.1e.353q.vcex

Which statement describes the recommended deployment of DNS and DHCP servers in the Cisco Network Architecture for the Enterprise?

• A: Place the DHCP and DNS servers in the Enterprise Campus Access layer and Enterprise branch.
• B: Place the DHCP and DNS servers in the Enterprise Campus Server Farm layer and Enterprise branch.
• C: Place the DHCP server in the Enterprise Campus Core layer and Remote Access_VPN module with the DNS server in the Internet Connectivity module.
• D: Place the DHCP server in the Enterprise Campus Distribution layer with the DNS server in the Internet Connectivity module.

Correct Answer: B

For the Enterprise Campus, DHCP and internal DNS servers should be located in the Server Farm and they should be redundant. External DNS servers can be placed redundantly at the service provider facility and at the Enterprise branch. 

 

   

Your company's Cisco routers are operating with EIGRP. You need to join networks with an acquisition's heterogeneous routers at 3 sites, operating with EIGRP and OSPF. 
Which describes the best practice for routing protocol deployment?

• A: Apply OSPF throughout both networks
• B: Apply one-way redistribution exclusively at each location
• C: Apply two-way redistribution exclusively at each location
• D: Apply two-way redistribution at each location with a route filter at only one location
• E: Apply two-way redistribution at each location with a route filter at each location
• F: Apply EIGRP with the same autonomous system throughout both networks

Correct Answer: E

Which two routing protocols converge most quickly? (Choose two.)

• A: RIPv1
• B: RIPv2
• C: BGP
• D: OSPF
• E: EIGRP

Correct Answer: DE

Which of these is the equation used to derive a 64 Kbps bit rate?

• A: 2 x 8 kHz x 4-bit code words
• B: 8 kHz x 8-bit code words
• C: 2 x 4-bit code words x 8 kHz
• D: 2 x 4 kHz x 8-bit code words

Correct Answer: D

Which one of these statements is an example of how trust and identity management solutions should be deployed in the enterprise campus network?

• A: Authentication validation should be deployed as close to the data center as possible.
• B: Use the principle of top-down privilege, which means that each subject should have the privileges that are necessary to perform their defined tasks, as well as all the tasks for those roles below them.
• C: Mixed ACL rules, using combinations of specific sources and destinations, should be applied as close to the source as possible.
• D: For ease of management, practice defense in isolation - security mechanisms should be in place one time, in one place.

Correct Answer: C

With deterministic Wireless LAN Controller redundancy design, the different options available to the designer have their own strengths. 
Which one of these statements is an example of such a strength?

• A: Dynamic load balancing, or salt-and-pepper access point design, avoids the potential impact of oversubscription on aggregate network performance.
• B: N+N redundancy configuration allows logically grouping access points on controllers to minimize intercontroller roaming events.
• C: N+N+1 redundancy configuration has the least impact to system management because all of the controllers are colocated in an NOC or data center.
• D: N+1 redundancy configuration uses Layer 3 intercontroller roaming, maintaining traffic on the same subnet for more efficiency.

Correct Answer: B

With such an arrangement there is no complex mesh of access points & controllers. 
Link: http://www.cisco.com/web/learning/le31/le46/cln/qlm/CCDA/design/understanding-wireless-network-controller-technology-3/player.html
N+N WLC Redundancy 
With N+N redundancy, shown in Figure 5-14, an equal number of controllers hack up each other. For example, a pair of WLCs on one floor serves as a backup to a second pair on another floor. The top WLC is primary for API and AP2 and secondary for AP3 and AP4. The bottom WLC is primary for AP3 and AP4 and secondary for API and AP2. There should be enough capacity on each controller to manage a failover situation. 

 

   
  
N+N+1 WLC Redundancy 
With N+N+1 redundancy, shown in Figure 5-15, an equal number of controllers back up each other (as with N+N), plus a backup WLC is configured as the tertiary WLC for the APs. N+N+1 redundancy functions the same as N+N redundancy plus a tertiary controller that backs up the secondary controllers. The tertiary WLC is placed in the data center or network operations center 

 

   

When designing the threat detection and mitigation portion for the enterprise data center network, which of the following would be the most appropriate solution to consider?

• A: 802.1X
• B: ACLs in the core layer
• C: Cisco Security MARS
• D: Cisco Firewall Services Module

Correct Answer: C

You have a campus network that consists of only Cisco devices. You have been tasked to discover the device platforms, the IOS versions, and an IP address of each device to map the network. Which proprietary protocol will assist you with this task?

• A: SNMP
• B: TCP
• C: CDP
• D: ICMP
• E: LLDP

Correct Answer: C

Which three technologies are recommended to be used for WAN connectivity in today's Enterprise Edge designs? (Choose three.)

• A: DWDM
• B: Metro Ethernet
• C: Frame Relay
• D: MPLS VPN
• E: ISDN
• F: DSL
• G: Wireless

Correct Answer: ABD

WAN backup over the Internet is often used to provide primary connection redundancy. 
Which is the most important consideration when passing corporate traffic over the public Internet?

• A: security
• B: static versus dynamic routing
• C: bandwidth
• D: QoS
• E: latency

Correct Answer: A