Download Managing Industrial Networks with Cisco Networking Technologies.CertDumps.200-401.2019-08-10.1e.44q.vcex

Download Exam

File Info

Exam Managing Industrial Networks with Cisco Networking Technologies
Number 200-401
File Name Managing Industrial Networks with Cisco Networking Technologies.CertDumps.200-401.2019-08-10.1e.44q.vcex
Size 791 Kb
Posted August 10, 2019
Downloads 21
Download Managing Industrial Networks with Cisco Networking Technologies.CertDumps.200-401.2019-08-10.1e.44q.vcex

How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase

Coupon: MASTEREXAM
With discount: 20%



 
 



Demo Questions

Question 1

Drag and Drop Question

Correct Answer: Exam simulator is required




Question 2

Which of the following correctly pairs the dotted decimal subnet mask with the correct number of binary bits that represent the subnet mask?

  • A: 255.255.255.192 and /25
  • B: 255.255.255.248 and /28
  • C: 255.255.255.224 and /26
  • D: 255.255.255.248 and /27
  • E: 255.255.255.240 and /28
  • F: 255.255.255.240 and /16

Correct Answer: E




Question 3

Refer to the exhibit. Host 3 on Network A is sending data to Host 8 on Network B.
Which address is the default gateway of Host 3?




  • A: the address of the switch interface that is connected to router interface Fa0/0
  • B: the address of the switch interface that is connected to router interface Fa0/1
  • C: the address of the host that is connected to Network A
  • D: the address of the host that is connected to Network B
  • E: the address of the router interface Fa0/0
  • F: the address of the router interface Fa0/1

Correct Answer: E




Question 4

What are two benefits of a star network topology? (Choose two.)

  • A: Disruption of the entire network is not required when adding new machines.
  • B: Any problem which leaves the network inoperable can be traced to the central hub.
  • C: This network type requires less cable as compared to linear bus topology.
  • D: The performance of one of the numerous nodes cannot reflect on the performance of other nodes.
  • E: The performance of the entire network is directly dependent on the performance of the hub.

Correct Answer: AB




Question 5

A small manufacturing company has a Class C network address on the plant floor and needs to create five subnets, each accommodating 25 endpoints. Which subnet mask needs to be configured?

  • A: 255.255.240.0
  • B: 255.255.255.128
  • C: 255.255.255.192
  • D: 255.255.255.224
  • E: 255.255.255.240
  • F: 255.255.255.248

Correct Answer: D




Question 6

Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the configuration?

  • A: Telnet encrypts only the login information, not the entire transmission.
  • B: SSH requires fewer network resources and no additional configuration.
  • C: Telnet is more difficult to use and configure than SSH.
  • D: SSH encrypts the login and session information.

Correct Answer: D




Question 7

Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time after a link failure?

  • A: Rapid Per-VLAN Spanning Tree Protocol
  • B: Resilient Ethernet Protocol
  • C: Multiple Spanning Tree Protocol
  • D: Spanning Tree Protocol

Correct Answer: B




Question 8

Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)

  • A: designated ports
  • B: duplex operating mode
  • C: fast mode ports
  • D: root bridge
  • E: root ports
  • F: BDPU priority

Correct Answer: ADE




Question 9

You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?

  • A: router#ping
  • B: router#tracert
  • C: router#show ip route
  • D: router#show cdp neighbors
  • E: router#traceroute

Correct Answer: E




Question 10

The network administrator is using a Windows PC application that is called putty.exe for remote communication to a switch for network troubleshooting. Which two protocols could be used during this communication? (Choose two).

  • A: SNMP
  • B: HTTP
  • C: Telnet
  • D: RMON
  • E: SSH

Correct Answer: CE










CONNECT US

Facebook

Twitter

PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount!



HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files