Download Cisco.CertDumps.300-135.2017-10-07.17e.65q.vcex

Download Exam

File Info

Exam Troubleshooting and Maintaining Cisco IP Networks (TSHOOT v2.0)
Number 300-135
File Name Cisco.CertDumps.300-135.2017-10-07.17e.65q.vcex
Size 11.28 Mb
Posted October 07, 2017
Downloads 67
Download Cisco.CertDumps.300-135.2017-10-07.17e.65q.vcex

How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Purchase

Coupon: MASTEREXAM
With discount: 20%



 
 



Demo Questions

Question 1

The implementations group has been using the test bed to do a `proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address. 
Use the supported commands to isolated the cause of this fault and answer the following questions. 
What is the solution to the fault condition?

  • A: R1
  • B: R2
  • C: R3
  • D: R4
  • E: DSW1
  • F: DSW2
  • G: ASW1
  • H: ASW2

Correct Answer: G

The problem here is that VLAN 10 is not configured on the proper interfaces on switch ASW1.




Question 2

The implementations group has been using the test bed to do a ,,proof-of-concept that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address. 
Use the supported commands to isolated the cause of this fault and answer the following questions. 
The fault condition is related to switch technology?

  • A: NTP
  • B: Switch-to-Switch Connectivity
  • C: Loop Prevention
  • D: Access Vlans
  • E: VLAN ACL Port ACL
  • F: Switch Virtual Interface
  • G: Port Security

Correct Answer: D

The problem here is that VLAN 10 is not configured on the proper interfaces on switch ASW1.




Question 3

The implementations group has been using the test bed to do a `proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address. 
Use the supported commands to isolated the cause of this fault and answer the following questions. 
What is the solution to the fault condition?

  • A: In Configuration mode, using the interface range Fastethernet 1/0/1  2, then switchport mode access vlan 10 command.
  • B: In Configuration mode, using the interface range Fastethernet 1/0/1  2, then switchport access mode vlan 10 command.
  • C: In Configuration mode, using the interface range Fastethernet 1/0/1  2, then switchportvlan 10 access command.
  • D: In Configuration mode, using the interface range Fastethernet 1/0/1  2, then switchport access vlan 10 command.

Correct Answer: D

The problem here is that VLAN 10 is not configured on the proper interfaces on switch ASW1.




Question 4

Exhibit:

 

   

A network administrator is troubleshooting an EIGRP connection between RouterA, IP address 10.1.2.1, andRouterB, IP address 10.1.2.2. Given the debug output on RouterA, which two statements are true? (Choose two.)

  • A: RouterA received a hello packet with mismatched autonomous system numbers.
  • B: RouterA received a hello packet with mismatched hello timers.
  • C: RouterA received a hello packet with mismatched authentication parameters.
  • D: RouterA received a hello packet with mismatched metric-calculation mechanisms.
  • E: RouterA will form an adjacency with RouterB.
  • F: RouterA will not form an adjacency with RouterB.

Correct Answer: DF




Question 5

When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful. What is the next thing that should be checked?

  • A: Verify that the EIGRP hello and hold timers match exactly.
  • B: Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command.
  • C: Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command.
  • D: Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.

Correct Answer: D




Question 6

Refer to the exhibit. 

 

   

How would you confirm on R1 that load balancing is actually occurring on the default-network (0.0.0.0)?

  • A: Use ping and the show ip route command to confirm the timers for each default network resets to 0.
  • B: Load balancing does not occur over default networks; the second route will only be used for failover.
  • C: Use an extended ping along with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.
  • D: Use the traceroute command to an address that is not explicitly in the routing table.

Correct Answer: D




Question 7

Which IPsec mode will encrypt a GRE tunnel to provide multiprotocol support and reduced overhead?

  • A: 3DES
  • B: multipoint GRE
  • C: tunnel
  • D: transport

Correct Answer: D




Question 8

Which three features are benefits of using GRE tunnels in conjunction with IPsec for building site-to-site VPNs? (Choose three.)

  • A: allows dynamic routing over the tunnel
  • B: supports multi-protocol (non-IP) traffic over the tunnel
  • C: reduces IPsec headers overhead since tunnel mode is used
  • D: simplifies the ACL used in the crypto map
  • E: uses Virtual Tunnel Interface (VTI) to simplify the IPsec VPN configuration

Correct Answer: ABD




Question 9

Which statement is true about an IPsec/GRE tunnel?

  • A: The GRE tunnel source and destination addresses are specified within the IPsec transform set.
  • B: An IPsec/GRE tunnel must use IPsec tunnel mode.
  • C: GRE encapsulation occurs before the IPsec encryption process.
  • D: Crypto map ACL is not needed to match which traffic will be protected.

Correct Answer: C




Question 10

A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch network and suggest resolutions to the problems. 

 

   

 
   

 
   

 
   

 
   
 
PC2 in VLAN 200 is unable to ping the gateway address 172.16.200.1; identify the issue.

  • A: VTP domain name mismatch on SW4
  • B: VLAN 200 not configured on SW1
  • C: VLAN 200 not configured on SW2
  • D: VLAN 200 not configured on SW4

Correct Answer: C

By looking at the configuration for SW2, we see that it is missing VLAN 200, and the "switchport access vlan 200" command is missing under interface eth 0/0:

 
   










CONNECT US

Facebook

Twitter

PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount!



HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files