Download CWNP.CWNA-109.ExamDumps.2024-06-13.43q.tqb

https://7signal.com/802-11ac-migration-part-2-whats-nobodys-telling-you-about-80mhz-and-160mhz-channel-bondingThe clients are all 802.11n STAs or lower is the likely cause of this behavior. If a WLAN with 100 802.11ac access points is configured to use 80 MHz channels, but only 40 MHz communications are seen in a particular BSS, it means that the clients in that BSS do not support 80 MHz channels. This could be because they are using older standards, such as 802.11n or lower, that do not support 80 MHz channels. Alternatively, they could be using newer standards, such as 802.11ac or ax, but have their channel width settings limited to 40 MHz or lower due to device capabilities or configuration options. In either case, the AP will adapt to the client's channel width and use only 40 MHz of the 80 MHz allocated bandwidth to communicate with them. This will reduce the potential throughput and efficiency of the WLAN.Reference:, Chapter 3, page 111; , Section 3.2

VHT TXOP (Very High Throughput Transmit Opportunity) power save is a feature introduced with the 802.11ac amendment, which is designed to improve the power efficiency of devices connected to a WLAN. This feature enhances battery life in several ways, compared to the legacy Power Save mode:Enhanced Power Saving: VHT TXOP power save allows devices to disable more components of the WLAN transceiver when they are in a low power state. This reduces the power consumption during periods when the device is not actively transmitting or receiving data.Intelligent Wake-Up Mechanisms: It employs more sophisticated mechanisms for devices to determine when they need to wake up and listen to the channel, further reducing unnecessary power usage.Optimized Operation: This power save mode is optimized for the high-throughput environment of 802.11ac networks, allowing devices to efficiently manage power while maintaining high performance.Legacy Power Save mode, introduced in earlier versions of the 802.11 standards, does not provide the same level of component disablement or the intelligent wake-up mechanisms found in VHT TXOP power save, making option B the correct answer.IEEE 802.11ac-2013 Amendment: Enhancements for Very High Throughput for Operation in Bands below 6 GHz.CWNA Certified Wireless Network Administrator Official Study Guide: Exam CWNA-109, by David D. Coleman and David A. Westcott.

An IBSS is used instead of a BSS is a network configuration that would result in multiple stations broadcasting Beacon frames with the same BSSID but with different source addresses. An IBSS (Independent Basic Service Set) is a type of WLAN that does not use an AP but rather allows stations to communicate directly with each other in a peer-to-peer manner. An IBSS is also known as an ad-hoc network or a peer-to-peer network. In an IBSS, each station generates its own Beacon frames to announce its presence and capabilities to other stations within range. The Beacon frames have the same BSSID, which is randomly generated by one of the stations when creating the IBSS, but they have different source addresses, which are the MAC addresses of each station's radio interface. The BSSID is used to identify the IBSS and prevent stations from joining other IBSSs with different BSSIDs.Reference:, Chapter 1, page 25; , Section 1.1