Download Nokia.4A0-110.Pass4Sure.2019-03-26.15q.vcex

Download Exam

File Info

Exam Nokia Advanced Troubleshooting
Number 4A0-110
File Name Nokia.4A0-110.Pass4Sure.2019-03-26.15q.vcex
Size 2 MB
Posted Mar 26, 2019
Download Nokia.4A0-110.Pass4Sure.2019-03-26.15q.vcex

How to open VCEX & EXAM Files?

Files with VCEX & EXAM extensions can be opened by ProfExam Simulator.

Download
ProfExam Simulator

Purchase

Coupon: MASTEREXAM
With discount: 20%





Demo Questions

Question 1

Two routers are physically connected running ISIS. ISIS L2 adjacency is up and running but L1 adjacency is not up. Review the configuration information shown below: Which of the following statement best describe the cause of the problem? Select one answer only. 
  


  1. The ISIS interface level is not configured on both routers
  2. The ISIS interface type should be configured as point-to-point interfaces
  3. ISIS System IDs are not configured on both routers
  4. ISIS Area addresses are not configured on both routers
  5. ISIS level capacity are not configured on both routers
Correct answer: D



Question 2

L1 ISIS adjacency is up between two routers (Node-1 and Node-2) with MD5 authentication configured. During a maintenance window, an operator was planning to change one of the ISIS hello authentication key from admin to admin123. After removing the hello authentication key from Node-1 (no change on Node-2 side), the ISIS adjacency stayed up. The operator decided to fall back to the original configuration and called Alcatel for support. Which of the following statement best describe the cause of the problem? Select one answer only.  
  


  1. The ISIS hello authentication key was not configured properly in the first place, that's why removing the authentication key does not impact the adjacency
  2. The ISIS authentication key is the same as the hello authentication key, therefore removing hello authentication key does not impact the adjacency
  3. The system interface is missing from the ISIS configuration, therefore ISIS is not working properly even before the change
  4. ISIS hello authentication key is only used for hello packet exchange. It does not affect ISIS adjacency
  5. ISIS hello authentication key is not used to bring up ISIS adjacency when traffic-engineering is enabled on the routers
Correct answer: B



Question 3

What are the typical RIP related issues found during troubleshooting?


  1. Interface filters
  2. Broadcast/Multicast mismatch
  3. Area id not match with neighbor
  4. Group name not match with neighbor
  5. Hop count too high
Correct answer: ABE



Question 4

Node A has an active BGP route 10.1.1.1 in its routing table, but the same route is not found in Node D routing table. 
Which of the following configurations are required to resolve this problem? 
  


  1. Add Interface X to OSPF on Node B as passive interface
  2. Redistribute interface address Y and Z into BGP
  3. ISIS Enable route-reflection on Node B
  4. Enable next-hop-self on Node C
  5. Enable route-reflection on Node C
Correct answer: AE



Question 5

A LSP is configured with one primary path and one secondary path as below. 
What configuration is required to make the LSP non-revertive. Choose the best answer.  
  


  1. Turn off CSPF and remove all the bandwidth reservations
  2. Remove the primary path and configure both paths as secondary
  3. Under asp toRouter3? configure on-revertive
  4. It is not possible to configure the LSP as non-revertive
  5. MPLS fast re-route has to be enabled to make it non-revertive
Correct answer: B



Question 6

Which one of the following CLI can be used to view all management VPLS configured on a 7x50?


  1. Show service service-using m-vpls
  2. Show service service-using
  3. Show router vpls detail
  4. Show service id <service id> base
  5. There is no CLI command to display management VPLS
Correct answer: B



Question 7

Node 1 and Node 2 are directly connected running LDP. The system ip address of Node 2 is 10.10.10.1.2. Based on the following display, why is the sdp down?  
  


  1. Local SDP id does not match with the remote sdp id.
  2. Far End IP address is not reachable.
  3. Keepalive has to be enable on the SDP.
  4. LDP is not enable on the remote node's interface.
  5. Targeted LDP session is disabled on the remote node.
Correct answer: A



Question 8

If a router needs to support services offering of 1514 byte service payload over POS with MPLS FRR, what is the physical MTU size required on the network ports?


  1. 1524
  2. 1536
  3. 1540
  4. 1514
  5. 1528
Correct answer: E



Question 9

What are the possible logging destinations supported on the Alcatel 7x50?


  1. Syslog
  2. Session
  3. FTP server
  4. Memory log
  5. Compact flash
Correct answer: ABDE



Question 10

Which command should be used to enable automatic synchronization for all software images and configuration on the Alcatel 7x50?


  1. Admin redundancy synchronization boot-env
  2. Admin redundancy synchronization config
  3. Configure redundancy synchronize boot-env
  4. Configure redundancy synchronize config
  5. It is enabled by default
Correct answer: C









CONNECT US

Facebook

Twitter

PROFEXAM WITH A 20% DISCOUNT

You can buy ProfExam with a 20% discount!

Get Now!


HOW TO OPEN VCEX FILES

Use ProfExam Simulator to open VCEX files